The intergranular corrosion （IGC） character of tin-added B316LX and the influence of tin addition on IGC susceptibility were investigated by DL-EPR, oxalic acid etch test and transmission electron microscopy. IGC susceptibility of B316LX is mainly caused by the precipitation of M23C6 carbide and intermetallic Laves phase. DL-EPR test is unsuitable to evaluate the IGC susceptibility of B316LX with long-time sensitization, because more carbides and inter- metallic phases are formed at grain boundaries and inside the grains, which induce more severe IGC and pits attacks. Tin addition increases the IGC susceptibility, maybe due to diffusion of tin toward grain boundaries.
Min SunYuan-Yuan YangMing LuoLai-Zhu JiangYi-Ming JiangJin Li
The pitting corrosion resistance of duplex stainless steels UNS S31803 annealed at different temperatures ranging from 1050 ℃ to 1200 ℃ for 24 h has been investigated by means of potentiostatic critical pitting temperature （CPT）. The microstructural evolution and pit morphologies of the specimens were studied through optical microscopy and scanning electron microscopy. The potentiostatic CPT measurements show that the CPT was elevated with the annealing temperature increased from 1050 ℃ to 1150℃ and decreased as the temperature further increased to 1200 ℃. The specimens annealed at 1150 ℃ exhibited the highest CPTand the best pitting corrosion resistance. The pit morphologies show that the pit initiation sites transfer from austenite phase to ferrite phase as the annealing temperature increases. The results were explained by the variation of pitting resistance equivalent number （PREN） of ferrite and austenite phases as the annealing temperature was varied.
The effect of solution annealing temperature ranging from 950 to 1 200 ℃ on the microstructure and corrosion performance of duplex stainless steel （DSS） 2204 were investigated. The proportion of the ferrite phase increased while the austenite phase decreased and the ferrite stabilizing elements diluted in the ferrite phase with the increase of annealing temperature. The critical pitting temperature （CPT） of specimens annealed at 1000℃ was higher than those annealed at 950℃, whereas further increasing the annealing temperature to 1200℃ decreased the CPT. The pitting initiation sites were observed in the austenite phase, at the boundary of ferrite/austenite phase and inside the ferrite phase for specimens annealed at 950, 1000℃ and exceeding 1 100℃, respectively. The evolution trend of the CPT and the pit initiation site were analyzed by the pitting resistance equivalent number.
