On the basis of the new type Boussinesq equations (Madsen et al.,2002),a set of equations explicitly including the effects of currents on waves are derived.A numerical implementation of the present equations in one dimension is described.The numerical model is tested for wave propagation in a wave flume of uniform depth with current present.The present numerical results are compared with those of other researchers.It is validated that the present numerical model can reasonably reflect the nonlinear influences of currents on waves.Moreover,the effects of inputting different incident boundary conditions on the calculated results are studied.
For the floating structures in deepwater, the coupling effects of the mooring lines and risers on the motion responses of the structures become increasingly significant. Viscous damping, inertial mass, current loading and restoring, etc. from these slender structures should be carefully handled to accurately predict the motion responses and line tensions. For the spar platforms, coupling the mooring system and riser with the vessel motion typically results in a reduction in extreme motion responses. This article presents numerical simulations and model tests on a new cell-truss spar platform in the State Key Laboratory of Ocean Engineering in Shanghai Jiaotong University. Results from three calculation methods, including frequency-domain analysis, time-domain semi-coupled and fully-coupled analyses, were compared with the experimental data to find the applicability of different approaches. Proposals for the improvement of numerical calculations and experimental technique were tabled as well.
Hybrid model testing technique is widely used in verification of a deepwater floating structure and its mooring system,but the design of the truncated mooring systems which can reproduce both static and dynamic response same as the full-depth mooring system is still a big challenge,especially for the mooring systems with large truncation.A Cell-Truss Spar operated in 1500 m water depth is verified in a wave basin with 4 m water depth.A large truncation factor arises even though a small model scale 1:100 is adopted.Computer program modules for analyzing the static and frequency domain dynamic response of mooring line are combined with multi-objective genetic algorithm NSGA-II to optimize the truncated mooring system.Considering the asymmetry of layout of mooring lines,two different truncated mooring systems are respectively designed for both directions in which the restoring forces of the mooring system are quite different.Not only the static characteristics of the mooring systems are calibrated,but also the dynamic responses of the single truncated mooring line are evaluated through time domain numerical simulation and model tests.The model test results of 100-year storm in the GOM are reconstructed and extrapolated to a full depth.It is found that the experimental and numerical results of Spar wave frequency motion agree well,and the dynamic responses of the full-depth mooring lines are better reproduced,but the low frequency surge motion is overestimated due to the smaller mooring-induced damping.It is a feasible method adopting different truncated mooring systems for different directions in which the restoring force characteristics are quite different and cannot be simulated by one truncated mooring system.Hybrid verification of a deepwater platform in wave basin with shallow water depth is still feasible if the truncated mooring systems are properly designed,and numerical extrapolation is necessary.
