Based on the 2-D flow and sediment numerical model of the Yangtze Estuary and the Hangzhou Bay, the characteristics of water and sediment exchange in their joint waters is studied through quantitative calculation and analysis of the characteristics of water flow and sediment transportation. The results show that there is periodical water and sediment exchange in this joint waters, that the net water exchange appears mainly between 0 - 6 m depth （theoretical datum plane, the same below） offshore and the maximum is near the depth of 2 m, and that the net sediment exchange mainly appears between 0 - 5 m depth and the maximum is near the depth of 3 m, indicating that the range of water flow passage is different from that of sediment transport from the Yangtze Estuary to the Hangzhou Bay. Combined with the results of numerical simulation, this paper also analyzes the hydrodynamical mechanism influencing water and sediment exchange between the Yangtze Estuary and the Hangzhou Bay, including tidal fluctuation, tidal current kinetic energy, tide-induced residual current and the trace of water particles. Finally, the sediment transportation passage on the Nanhui tidal fiat is discussed, and the results show that sediment is transported into the Hangzhou Bay from the south side of Shipilei, while sediment is brought back to the South Channel of the Yangtze Estuary from the north side.
Many observed data show that the near-bed tidal velocity profile deviates from the usual logarithmic law. The amount of deviation may not be large, but it results in large errors when the logarithmic velocity profile is used to calculate the bed roughness height and friction velocity （or shear stress）. Based on their investigation, Kuo et al. （1996） indicate that the deviation amplitude may exceed 100%. On the basis of fluid dynamic principle, the profile of the near-bed tidal velocity in estuarine and coastal waters is established by introducing Prandtl＇ s mixing length theory and Von Kannan selfsimilarity theory. By the fitting and calculation of the near-bed velocity profde data observed in the west Solent, England, the results are compared with those of the usual logarithmic model, and it is shown that the present near-bed tidal velocity profile model has such advantages as higher fitting precision, and better inner consistency between the roughness height and friction velocity. The calculated roughness height and friction velocity are closer to reality. The conclusions are validated that the logarithmic model underestimates the roughness height and friction velocity during tidal acceleration and overestimates them during tidal deceleration.
