0.67BiFeO_(3)-0.33BaTiO_(3)multiferroic ceramics doped with x mol%MnO_(2)(x=2-10)were synthesized by solid-state reaction.The formation of a perovskite phase with rhombohedral symmetry was confirmed by X-ray diffraction(XRD).The average grain sizes were reduced from 0.80mm to 0.50mm as increasing the Mn-doped levels.Single crystalline nature of the grains was revealed by high-resolution transmission electron microscopy(HRTEM)images and electron diffraction patterns.Polar nano-sized ferroelectric domains with an average size of 9 nm randomly distributed in the ceramic samples were revealed by TEM images.Ferroelectric domain lamellae(71°ferroelectric domains)with an average width of 5 nm were also observed.Vibrational modes were examined by Raman spectra,where only four Raman peaks at 272 cm^(-1)(E-4 mode),496 cm^(-1)(A_(1)-4 mode),639 cm^(-1),and 1338 cm^(-1)were observed.The blue shifts in the E-4 and A_(1)-4 Raman mode frequencies were interpreted by a spring oscillator model.The dieletric constants of the present ceramics as a function of the Mn-doped levels exhibited a V-typed curve.They were in the range of 350-700 measured at 10^(3)Hz,and the corresponding dielectric losses were in range of 0.43-0.96,approaching to 0.09 at 10^(6)Hz.
Molten salt synthesis （MSS） method has advantages of the simplicity in the process equipment, versatile and large-scale synthesis, and friendly environment, which provides an excellent approach to synthesize high pure oxide powders with controllable compositions and morphologies. Among these oxides, perovskite oxides with a composition of ABO3 exhibit a broad spectrum of physical properties and functions （e.g. ferroelectric, piezoelectric, magnetic, photovoltaic and photocatalytic properties）. The downscaling of the spatial geometry of perovskite oxides into nanometers result in novel properties that are different from the bulk and film counterparts. Recent interest in nanoscience and nanotechnology has led to great efforts focusing on the synthesis of low-dimensional perovskite oxide nanostructures （PONs） to better understand their novel physical properties at nanoscale. Therefore, the low-dimensional PONs such as perovskite nanoparticles, nanowires, nanorods, nanotubes, nanofibers, nanobelts, and two dimensional oxide nanostructures, play an important role in developing the next generation of oxide electronics. In the past few years, much effort has been made on the synthesis of PONs by MSS method and their structural characterizations. The functional applications of PONs are also explored in the fields of storage memory, energy harvesting, and solar energy conversion. This review summarizes the recent progress in the synthesis of low-dimensional PONs by MSS method and its modified ways. Their structural char- acterization and physical properties are also scrutinized. The potential applications of low-dimensional PONs in different fields such as data memory and storage, energy harvesting, solar energy conversion, are highlighted. Perspectives concerning the future research trends and challenges of low-dimensional PONs are also outlined. ~ 2017 Published by Elsevier Ltd on behalf of The editorial office of Journal of Materials Science ＆ Technology.
