Due to X-ray attenuation being approximately proportional to material density,it is possible to measure the inner density through Industrial Computed Tomography(ICT) images accurately. In practice,however,a number of factors including the non-linear effects of beam hardening and diffuse scattered radiation complicate the quantitative measurement of density variations in materials. This paper is based on the linearization method of beam hardening correction,and uses polynomial fitting coecient which is obtained by the curvature of iron polychromatic beam data to fit other materials. Through theoretical deduction,the paper proves that the density measure error is less than 2% if using pre-filters to make the spectrum of linear accelerator range mainly 0.3 MeV to 3 MeV. Experiment had been set up at an ICT system with a 9 MeV electron linear accelerator. The result is satisfactory. This technique makes the beam hardening correction easy and simple,and it is valuable for measuring the ICT density and making use of the CT images to recognize materials.
