Atmospheric high frequency cold plasma jet was applied to modify Ni/SiO2 cata-lysts.The catalysts prepared by two different methods with plasma jet were compared with con-ventional catalysts.BET,XRD,H2-TPD and high-resolution transmission electron microscopy（HRTEM）were used to characterize these catalysts.The results showed that the catalyst preparedwith plasma jet had higher nickel dispersion,larger specific surface area and smaller nickel particlesize,about 5 nanometres.Detailed analyses revealed that improved structure and characteristic ofthe plasma catalyst were benefited from the large amount of hydrogen atoms in the plasma jet,bywhich the catalyst reduction can be easily achieved in shorter period of time at lower temperature,thus avoiding sintering and conglomeration of the active particles and the support.The activityof catalysts was investigated in the methane reforming with CO2.It is shown that the conversionsof CH4 and CO2,the yields of H2 and CO were all significantly increased for the plasma catalysts.
A novel plasma atmospheric pressure abnormal glow discharge was used to investigate synthesis gas production from reforming methane and carbon dioxide. Special attentions were paid to the discharge characteristics and CH4, CO2 conversion, H2, CO selectivity, and ratio of H2/CO varied with the changing of discharging power, the total flux, and the ratio of CH4/CO2. Experiments were performed in wider operation variables, the discharging power of 240 to 600 W, the CH4/CO2 of 0.2 to 1.0 and the total flux of 140 to 500 mL/min. The experiments showed that the conversion of CH4 and CO2 was up to 91.9% and 83.2%, the selectivity of CO and H2 was also up to 80% and 90% and H2/CO mole ratio was 0.2 to 1.2, respectively. A brief analysis for discharge characteristics and the experimental results were given.
Methane conversion to C2 hydrocarbons has been investigated with the addition of hydrogen in a plasma reactor of abnormal glow discharge at atmospheric pressure. The aim of this experiment is to minimize coke formation and improve discharge stability. The typical conditions in the experiment are 300 ml of total feed flux and 400 W of discharge power. The experimental results show that methane conversion is from 91.6% to 35.2% in mol, acetylene selectivity is from 90.2% to 57.6%, and ethylene selectivity is approximately from 7.8% to 3.6%, where the coke increases gradually along with the increase of CH4/H2 from 2 : 8 to 9 : 1. A stable discharge for a considerable running time can be obtained only at a lower ratio of CH4/H2 = 2: 8 or 3: 7. These phenomena indicate that the coke deposition during methane conversion is obviously reduced by adding a large amount of hydrogen during an abnormal glow discharge A qualitative interpretation is presented, namely, with abundant hydrogen, the possibility that hydrogen molecules are activated to hydrogen radicals is increased with the help of the abnormal glow discharge. These hydrogen radicals react with carbon radicals to form C2 hydrocarbon products. Therefore, the deposition of coke is restrained.
