Currently,most researches use signals,such as the coil current or voltage of solenoid,to identify parameters;typically,parameter identification method based on variation rate of coil current is applied for position estimation.The problem exists in these researches that the detected signals are prone to interference and difficult to obtain.This paper proposes a new method for detecting the core position by using flux characteristic quantity,which adds a new group of secondary winding to the coil of the ordinary switching electromagnet.On the basis of electromagnetic coupling theory analysis and simulation research of the magnetic field regarding the primary and secondary winding coils,and in accordance with the fact that under PWM control mode varying core position and operating current of windings produce different characteristic of flux increment of the secondary winding.The flux increment of the electromagnet winding can be obtained by conducting time domain integration for the induced voltage signal of the extracted secondary winding,and the core position from the two-dimensional fitting curve of the operating winding current and flux-linkage characteristic quantity of solenoid are calculated.The detecting and testing system of solenoid core position is developed based on the theoretical research.The testing results show that the flux characteristic quantity of switching electromagnet magnetic circuit is able to effectively show the core position and thus to accomplish the non-displacement transducer detection of the said core position of the switching electromagnet.This paper proposes a new method for detecting the core position by using flux characteristic quantity,which provides a new theory and method for switch solenoid to control the proportional valve.
