基于SHAW(Simultaneous Heat and Water)模型,以基本观测要素、植被参数和土壤剖面水热观测数据为模型的输入,对河岸胡杨林的耗水过程、土壤剖面水分变化和能通量进行了较小时间尺度上的模拟研究。结果表明,采用SHAW模型模拟的胡杨耗水量与观测值间存在较大偏差。因此,为了进一步提升水热耦合SHAW模型在干旱区的实用性,引入了地下水位因子GSI(Groundwater-Soil water Interaction),建立了改进的SHAW(GSI-SHAW)模型,解决干旱区荒漠河岸林耗水过程模拟的方法问题。采用SHAW模型和GSI-SHAW模型对胡杨耗水量的模拟进行了对比研究。结果显示,SHAW模型和GSI-SHAW模型模拟的胡杨耗水量与观测值的相关性系数分别为0.853 3、0.907 5,其平均相对误差分别为21.4%、16.9%,可见,改进的SHAW模型的模拟值更加接近试验观测值。地下水位的考虑一定程度上提升了传统SHAW模型的模拟精度,为干旱区自然植被耗水量的计算提供了新的方法和科学依据。
Rainfall,runoff (surface runoff,interflow and groundwater runoff) and soil loss from 5 m × 15 m plots were recorded for 5 years (2001-2005) in an experiment with three treatments (cover,mulch and bare ground) on sloping red soil in southern China.Surface runoff and erosion from the Bahia grass (Paspalum notatum Flugge) cover plot (A) and mulch plot (B) during the 5 years were low,despite the occurrence of potentially erosive rains.In contrast,the bare plot (C) had both the highest surface runoff coefficient and the highest sediment yield.There were significant differences in interflow and surface runoff and no significant difference in groundwater runoff among plots.The runoff coefficients and duration of interflow and groundwater runoff were in the order plot B > plot A > plot C.Effects of Bahia grass cover were excellent,indicating that the use of Bahia grass cover can be a simple and feasible practice for soil and water conservation on sloping red soil in the region.
LI Xin-HuZHANG Zhan-YuYANG JieZHANG Guo-HuaWANG Bin
A field experiment was carried out to investigate the effects of different emitter discharge rates under drip irrigation on soil salinity distribution and cotton yield in an extreme arid region of Tarim River catchment in Northwest China. Four treatments of emitter discharge rates, i.e. 1.8, 2.2, 2.6 and 3.2 L/h, were designed under drip irrigation with plastic mulch in this paper. The salt distribution in the range of 70-cm horizontal distance and 100-cm vertical distance from the emitter was measured and analyzed during the cotton growing season. The soil salinity is expressed in terms of electrical conductivity （dS/m） of the saturated soil extract （ECe）, which was measured using Time Domain Reflector （TDR） 20 times a year, including 5 irrigation events and 4 measured times before/after an irrigation event. All the treatments were repeated 3 times. The groundwater depth was observed by SEBA MDS Dipper 3 automatically at three experimental sites. The results showed that the order of reduction in averaged soil salinity was 2.6 L/h 〉 2.2 L/h 〉 1.8 L/h 〉 3.2 L/h after the completion of irrigation for the 3-year cotton growing season. Therefore, the choice of emitter discharge rate is considerably important in arid silt loam. Usually, the ideal emitter discharge rate is 2.4-3.0 L/h for soil desalinization with plastic mulch, which is advisable mainly because of the favorable salt leaching of silt loam and the climatic conditions in the studied arid area. Maximum cotton yield was achieved at the emitter discharge rate of 2.6 L/h under drip irrigation with plastic mulch in silty soil at the study site. Hence, the emitter discharge rate of 2.6 L/h is recommended for drip irrigation with plastiic mulch applied in silty soil in arid regions.
This study presented the application of partial least squares regression (PLSR) in estimating daily pan evaporation by utilizing the unique feature of PLSR in eliminating collinearity issues in predictor variables. The climate variables and daily pan evaporation data measured at two weather stations located near Elephant Butte Reservoir,New Mexico,USA and a weather station located in Shanshan County,Xinjiang,China were used in the study. The nonlinear relationship between climate variables and daily pan evaporation was successfully modeled using PLSR approach by solving collinearity that exists in the climate variables. The modeling results were compared to artificial neural networks (ANN) models with the same input variables. The results showed that the nonlinear equations developed using PLSR has similar performance with complex ANN approach for the study sites. The modeling process was straightforward and the equations were simpler and more explicit than the ANN black-box models.
