Axial stiffness of ball screws has great effects on accuracy of positioning,dynamic characteristic and transmission efficiency. Axial contact stiffness modeling of ball screws is the key problem in dynamic analysis of ball screws. Aiming at obtaining axial stiffness of ball screws considering microscopic fractal characteristics of contact surfaces,a new analytical method is proposed to estimate axial contact stiffness of ball screws and combine the minimum excess principle with Mandelbort( MB)fractal theory in this research. The minimum excess principle is employed to conduct normal stress analysis. And the Mandelbort fractal theory is adopted to obtain contact stiffness in ball screws. The effectiveness of the proposed method is validated by the self-designed experiment. The comparison between theoretical results and experimental results demonstrates that axial contact stiffness of ball screws could be obtained by the proposed method.
Thin-walled parts have low stiffness characteristic. Initial residual stress of thin-walled blanks is an important influence factor on machining stability. The present work is to verify the feasibility of an initial residual stress measurement of layer removal method. According to initial residual stress experiment for casting ZL205 A aluminum alloy tapered thin-walled blank by a common method,namely hole-drilling method,three finite element models with initial residual stress are established to simulate the layer removal method in ABAQUS and ANSYS software. By analyzing the results of simulation and experiments,the cutting residual stress inlayer removal process has a significant effect on measurement results. Reducing cutting residual stress is helpful to improve accuracy of layer removal method.
Based on Hertz contact theory, contact area parameters between ball and raceway are calculated. Using the Creep theory of Cater and V-J theory, adhesive area and micro-slip area in the contact area are analyzed. It is considered that micro-adhesion wear of micro convex body in the slip area is the main reason for accuracy degradation of a linear ball guide pair. And, the characteristics of the contact area between ball and raceway of slider are characterized using the fractal function. Fractal parameters are obtained using the least squares fitting double logarithmic graph structure function. Considering the lubrication condition between the ball and rail of slider, stress analysis is carried out on the adhesive area. A fractal-creep model of contact surfaces is established in the micro-slip region. The fractal parameters of a certain guide rail are measured, and the wear degradation process of linear rolling guide is simulated. Finally, the relationship between wear and relative tangential velocity, normal load and running mileage of linear ball guide is obtained.
The contact stiffness and the error analysis have an important effect on the manufacture and the optimization of Ball Linear Guide Feed Unit( BLGFU). In order to analyze the contact stiffness and linear errors or angle errors of BLGFU,in this paper,the contact stress and deformation mechanics between the ball and rail is analyzed. Based on Hertz theory of contact and theory of the multi-body system,a model of the contact stiffness considering the changes in contact angle is established. With the increasing of the external load,the varying trend of the contact deformation can be obtained. Therefore, the motion accuracy degradation of the BLGFU can be analyzed. By using a special experimental device and test system of the rolling linear guide worktable,the horizontal contact stiffness and the vertical linear stiffness are obtained,respectively. By comparing the contact stiffness of the experiment dates and the simulation results,the variation tendency of two curves is consisted and the difference between the measured values and the theoretical values is less than 18%. It is obvious that the model of the contact stiffness considering changes of contact angle has accuracy and feasibility. Thus,while external force point locating at different positions; the contact stiffness and the accuracy analysis of the BLGFU are proved validity by simulations.
