Dynamic modeling and active control of a strap-on launch vehicle are studied in this paper. In the dynamic modeling, the double-compatible free-interface modal synthesis method is used to establish dynamic model of the system, and its model precision is compared with those of finite element method(FEM), fixedinterface modal synthesis method and free-interface modal synthesis method. In the active control, the swing angle of rocket motor is used as design variable, and the control law design based on the model of mass center motion is adopted to validate the system. Simulation results indicate that the double-compatible model synthesis method can properly approximate the FEM which is used as the benchmark solution, and the model precision of the double-compatible modal synthesis method is obviously higher than those of the fixed-interface and freeinterface modal synthesis methods. Based on the control law design, the deflection of mass center of the launch vehicle is very small.
In this paper, the on-orbit identification of modal parameters for a spacecraft is investigated. Firstly, the coupled dynamic equation of the system is established with the Lagrange method and the stochastic state-space model of the system is obtained. Then, the covariance-driven stochastic subspace identification(SSI-COV) algorithm is adopted to identify the modal parameters of the system. In this algorithm, it just needs the covariance of output data of the system under ambient excitation to construct a Toeplitz matrix, thus the system matrices are obtained by the singular value decomposition on the Toeplitz matrix and the modal parameters of the system can be found from the system matrices. Finally,numerical simulations are carried out to demonstrate the validity of the SSI-COV algorithm. Simulation results indicate that the SSI-COV algorithm is effective in identifying the modal parameters of the spacecraft only using the output data of the system under ambient excitation.
采用调谐质量阻尼器(Tuned Mass Damper,TMD)设计了铰接塔海洋平台的振动主动控制方法。首先给出了考虑重力梯度、水压力差、波浪力等外部载荷作用的系统动力学方程,并采用有限差分法对方程进行了离散,而后采用最优控制方法设计TMD的主动控制,并给出了TMD参数的设计方法。仿真结果表明,主动TMD的控制效果优于被动TMD,而且主动控制时的TMD位移量明显小于被动控制方法。
