The semi-solid deformation behavior of Ti14 was investigated using compression tests at deformation temperatures between 1 273 and 1 423 K with strain rate of 5×10-2s-1. Moreover, the fraction solid at different temperatures was also measured by image analysis. The results showed that the deformation temperature had strong effects on the flow stress, and the stress increased with the decrease of deformation temperature. The maximum stress depended greatly on the fraction solid, and a sharp decrease in stress occurred at a solid fraction between 0.94 and 0.98(temperature from 1 323 to 1 373 K). This decrease was related to the decrease in the amount of solid bridges between grains. Because of the partial solid/liquid segregation during deformation, the experimental strain rates were much lower than those calculated by the flow of liquid incorporating solid particles, which suggested that the main deformation mechanism between 1 323 and 1 373 K was still plastic deformation of solid particles.
The present work is focused on the microstructure and mechanical properties of Ti14 alloy with different semisolid deformation ratios during forging tests. The results revealed that the forging ratio had a significant effect on the precipitation of the alloy. Fewer plate-shaped Ti 2 Cu tended to precipitate on grain boundaries with higher forging ratios, and finally the plate-shaped Ti 2 Cu formed precipitate-free zones along grain boundaries with a forging ratio of 75%. The precipitation on grain boundaries was found to be controlled by a peritectic reaction. Large forging ratios accelerated the extrusion of liquid and resulted in less liquid along the prior grain boundaries, which reduced the peritectic precipitation in this region and formed precipitate-free zones during re-solidification. In addition, increasing the forging ratio could accelerate dynamic recrystallization, which is favorable for improving the semisolid formability. The tensile ductility increased with increasing forging ratio, and a mixed fracture mode, involving both cleavage and dimple fracture, was observed after forging with a forging ratio of 75%, which is attributed to the presence of precipitate-free zones formed along grain boundaries during semisolid processing.
