Mixing problems are most likely encountered and sometimes can be severe in scaling-up projects.Micro-mixing is an important aspect for fast or quasi-instantaneous reactions.Poor micro-mixing might produce more undesired by-products,leading to higher purification costs.This paper gives an extensive review and analysis of micro-mixing studies in single-and multiphase stirred tanks.The relevant experiment techniques,micro-mixing models and numerical approaches are critically reviewed and analyzed with remarks and perspectives.The reported studies on two-phase micro-mixing experiments and on the impact of the presence of the dispersed phases on turbu-lence have been limited to a narrow range of conditions.More importantly,disparities widely exist among different reports.Both Lagrangian and Eulerian models are based on oversimplified assumptions,which may lead to uncer-tainties or even unrealistic results.A heuristic model,which is from the perspective of CFD(computational fluid dynamics) and can cover the whole spectrum of scales and also focus on every sub-process,is desired in the future.
The present study summarizes the results of macro-and micro-mixing characteristics in an airlift internal loop reactor with low aspect ratio(H/D≤5) using the electrolytic tracer response technique and the method of parallel competing reactions respectively. The micro-mixing has never been investigated in airlift loop reactors. The dual-tip electrical conductivity probe technique is used for measurement of local bubble behavior in the reactor. The effects of several operating parameters and geometric variables are investigated. It is found that the increase in superficial gas velocity corresponds to the increase in energy input, liquid circulation velocity and shear rate, decreasing the macro-mixing time and segregation index. Moreover, it is shown that top clearance and draft diameter affect flow resistance. However, the bubble redistribution with a screen mesh on the perforated plate distributor for macro-mixing is insignificant. The top region with a high energy dissipation rate is a suitable location for feeding reactants. The analysis of present experimental data provides a valuable insight into the interaction between gas and liquid phases for mixing and improves the understanding of intrinsic roles of hydrodynamics upon the reactor design and operating parameter selection.
