The multi-block high-temperature superconducting (HTS) maglev system has more complicated dynamic characteristics than the single-block HTS maglev system. To study its vibration characteristics, we designed a maglev measurement system. The system responses at the excitation frequencies of 2, 3 and 15 Hz were examined. Results show that the responses under excitation frequencies of 2 and 3 Hz include a 6 Hz component, which means that the maglev system is a critical nonlinear system. Moreover, the 6 Hz component is much stronger than the 2 Hz or 3 Hz components in the response spectra. There is the interaction between excitation and response. Under an excitation fre-quency of 15 Hz, intensified low-frequency perturbations were observed.
The super-high speed high temperature superconductor (HTS) maglev evacuated tube transport (ETT) is a promising transport mode for the future. As a key component of the HTS maglev vehicle, the permanent magnet guide-ways (PMGs) with different geometrical configurations and iron yoke widths are analyzed by finite element method (FEM). The levitation force of a single onboard HTS maglev device over the designed PMG at different field cooling heights (FCH) is measured by magnetic levitation measurement system. Based on the designed PMG and experimental results, a preliminary scheme of subterranean super-high speed HTS maglev ETT is described in this paper. The HTS maglev ETT is mainly composed of an evacuated tube, HTS maglev vehicle, PMG, propulsion system, station, emergency rescue system, etc. In addition, a subterranean tube that consists of foundation tube and vacuum airproof layer is introduced. In order to convert the stress caused by the air pressure difference between inside and outside of the vehicle, a multi-circular vehicle body is designed. The vehicle is driven by a linear motor propulsion system under the control of a ground controlling system. The scheme of long-distance super-high speed passenger transportation is accomplished by the connection of different vehicles.
Based on the Navier-Stokes (N-S) equations of incompressible viscous fluids and the standard k-ε turbulence model with assumptions of steady state and two dimensional conditions, a simulation of the aerodynamic drag on a maglev train in an evacuated tube was made with ANSYS/FLOTRAN software under different vacuum pressures, blockage ratios, and shapes of train head and tail. The pressure flow fields of the evacuated tube maglev train under different vacuum pressures were analyzed, and then compared under the same blockage ratio condition. The results show that the environmental pressure of 1 000 Pa in the tube is the best to achieve the effect of aerodynamic drag reduction, and there are no obvious differences in the aerodynamic drag reduction among different streamline head shapes. Overall, the bluntshape tail and the blockage ratio of 0.25 are more efficient for drag reduction of the train at the tube pressure of 1 000 Pa.
