A promising electrochemical sensor was fabricated by electrodeposition of Pd nanoparticles (PdNPs) on poly(thiophene-3-acetic acid) (PTAA)-modified glassy carbon electrode (GCE), forming a PdNPs/PTAA composites-modified GCE (PdNPs/PTAA/GCE). Scanning electron microscope (SEM) and electrochemical techniques were used for the characterization of these composites. It was found that the PdNPs/PTAA layer was very uniform. Electrochemical experiments showed that this proposed PdNPs/PTAA composites-modified electrode exhibited excellent electrocatalytic activity towards the oxidation of hydrazine. Under the optimum conditions, the proposed sensor can be applied to the quantification of hydrazine with a wide linear range from 8.0 × 10-9 mol/L to 1.0 × 10-5 mol/L with a low detection limit of 2.67 ×10-9 mol/L. The experiment results also showed that the sensor exhibited good reproducibility and long-term stability, as well as high selectivity with no interference from other potential competing species.
Novel conducting oligocatecholborane (OCOB) with electrical conductivity of 3.73 × 10-2S cm-1 was successfully synthesized by low-potential electropolymerization of catecholborane (COB) in boron trifluoride diethyl etherate at 0.70 V versus Ag/AgCl. FT-IR and 1H-NMR spectra, together with the computational results, proved that COB was polymerized through the coupling at C(4) and C(5) positions and the reactive B―H bond was stable during the electrochemical polymerization. The resulting product was mainly composed of oligomers with short chain lengths by GPC and mass spectral results. The as-formed OCOB film showed good electrochemistry in monomer-free electrolytes with the electrochromic property from opaque blue to sap green. Fluorescence studies indicated that soluble OCOB can emit bright blue light under excitation of 365 nm UV light with the maximum emission at 396 nm and a fluorescence quantum yield of 0.21. The deposited OCOB also exhibited favorable thermal stability and smooth and compact morphology even at high magnifications.
A novel graphene oxide doped poly(hydroxymethylated-3,4-ethylenedioxythiophene)(PEDOT-MeOH/GO) composite film was synthesized and utilized as an efficient electrode material for simultaneous detection of rutin and ascorbic acid(AA). PEDOT-MeOH/GO films were synthesized on glassy carbon electrode(GCE) by a facile one-step electrochemical approach and were characterized by scanning electron microscopy, UV-Vis spectroscopy, FTIR spectra and electrochemical methods. Then the PEDOT-MeOH/GO/GCE was applied successfully in the simultaneous detection of rutin and AA. The results showed that the oxidation peak currents of rutin and AA obtained at the PEDOT-MeOH/GO/GCE were much higher than those at the traditional conducting polymer PEDOT/GO/GCE, PEDOT-MeOH/GCE, PEDOT/GCE and bare GCE. Under optimized conditions, the linear ranges for rutin and AA are 20 nmol/L-10 μmol/L and 8 μmol/L-1 mmol/L, respectively. The detection limit is 6 nmol/L for rutin and 2 μmol/L for AA(S/N = 3), which are lower than those of the reported electrochemical sensors.
Corrosion protection of the hull steel by the conventional epoxy paint containing a small amount of commercial poly(3,4-ethylenedioxythiophene)/poly(styrene sulfonate)(PEDOT/PSS),which is one of the most popular and successful inherently conducting polymers as the corrosion inhibitor was studied.The corrosion behavior of the samples was investigated in seawater by electrochemical impedance spectroscopy and open circuit potential.Scanning electron microscopy was used to observe the surface morphology of the samples after corrosion.It was found that adding a small amount of PEDOT/PSS to the epoxy resin can significantly improve its corrosion protection.
