为研究钙离子、镁离子在体内环境中对自硬性玻璃结晶行为的影响,为自硬性生物活性玻璃的临床应用提供依据,本文设计了CaO-P2O5-SiO2-CaF2(Ca-glass)和CaO-MgO-P2O5-SiO2-CaF2(CaMg-glass)系统玻璃并使用模拟体液(simulated body flu id,SBF)进行了研究。首先采用磷酸氢二氨[(NH4)2HPO4]/[NH4H2PO4]硬化液与Ca-glass、CaMg-glass制成硬化体,然后使用X射线衍射(XRD)、扫描电镜(SEM)、失重、力学分析等方法,研究硬化体在SBF中的结晶性、降解性和力学性能。实验结果表明,玻璃粉末与磷酸铵缓冲溶液反应形成了磷酸铵钙[(NH4)2.Ca(HPO4)2.H2O]硬化体。硬化体经过SBF浸泡,Ca-glass系统硬化体中部分磷酸铵钙转化成羟基磷灰石,而CaMg-glass系统硬化体仍然为磷酸铵钙。Ca-glass与CaMg-glass硬化体在SBF中浸泡28天分别降解19.4%和31.3%,抗压强度分别为93.14MPa和64.52MPa。镁离子的歧化作用是导致Ca-glass、CaMg-glass硬化体结晶性能、降解性能以及力学性能差别的主要原因。
A novel surface treatment method using 3-aminopropyltriethoxysilane （AMPTES）, was developed to immobilize the fluorescein molecule on nano-HAP （nanometer hydroxyapatite） powders. By pretreating the nano-HAP powders surface with AMPTES, fluorescein, chosen on the basis of the chemical structure of the nano- HAP powders, could be bound to the nano-HAP powders surface. The chemical compositions of nano-HAP before and after being labeled were characterized by Fourier transform infrared spectroscopy （FTIR） and X-ray photoelectron spectroscopy （XPS）. The morphology, phase composition, and the fluorescence characteristics of the nano-HAP powders with and without staining were also investigated. The FTIR and XPS results revealed that fluorescein had been successfully immobilized on the surface of AMPTES-bound nano-HAP powders via the acylamide bond formation between the -COOH of fluorescein and the -NH2 of AMPTES. The labeled nano-HAP powders possessed strong fluorescent intensity with a little deviation from the maximum emission wavelength of fluorescein. But the morphology and phase composition had no obvious alteration. Under fluorescence microscopy, the labeled nano-HAP powders, even after 24 h cell incubation, exhibited strong fluorescence.
本研究利用改进的溶胶-凝胶工艺合成了介孔硅基干凝胶。通过差热-热重(DTA-TG)、X-射线衍射(XRD)、红外光谱(FTIR)和N2等温吸附-脱附测试分析,以及扫描电镜(SEM)、透射电镜(TEM)观察,表征了硅基干凝胶的热效应、相态、结构、形貌特征,并对合成的硅基干凝胶进行了体外降解与细胞培养实验研究。测试结果表明:合成的硅基干凝胶为平均孔径3nm左右、最大比表面积901m2·g-1的介孔结构。体外模拟体液(Simulated body fluid,SBF)降解结果显示,低温处理的材料在42d内完全降解,直线拟合符合一级反应动力学方程。通过添加钙磷成分或高温煅烧处理可以调控干凝胶的降解速率,使硅基干凝胶的降解呈现直线式匀速降解的特征。体外细胞培养表明:硅基干凝胶可促进C2C12细胞(C3H小鼠肌原细胞)的分化和繁殖,证明材料的生物相容性良好。
