Petrogeochemical data indicate that after the end of seafloor spreading,residual magmatic activity still exists in the deep basin of the South China Sea.By using different viscous structure models beneath the fossil spreading center of the Southwest sub-basin we simulated the amount of melt produced,the length of the melting period,and the thermal evolution process in terms of geothermics and the buoyant decompression melting mechanism.We compared the results of our model with observed heat flow,seismic,and petrogeochemistry data.The results show that depletion buoyancy induced by buoyant decompression melting plays an important role in the melting process,while retention buoyancy,thermal buoyancy,and viscous shear force have only a weak influence on the melting process.From the length of the melting period,we determined that for the three viscous structures models the magmatic activity lasted about 5,12,and 15 Ma.Under the effect of buoyant depression melting,local high-temperature areas will develop under the basin,which can explain the low-velocity layer detected by seismic exploration in the middle and upper lithosphere of the Southwest sub-basin.We also simulated the possible lithology distribution beneath the fossil spreading center with the physical conditions of different viscous structure,different temperature structure,and different melting fraction,which provided a greater understanding of the rock petrogeochemical data of the deep sea basin in the South China Sea.
Site engineering seismic survey provides basic data for seismic effect analysis. As an important parameter of soil, shear-wave velocity is usually obtained through wave velocity testing in borehole. In this paper, the passive source surface-wave method is introduced into the site engineering seismic survey and practically applied in an engineering site of Shijingshan District. By recording the ubiquitous weak vibration on the earth surface, extract the dispersion curve from the surface-wave components using the SPAC method and obtain the shear-wave velocity structure from inversion. Over the depth of 42 m underground, it totally consists of five layers with interface depth of 3.31, 4.50, 7.23, 17.41, and 42.00 m; and shear-wave velocity of 144.0, 198.3, 339.4, 744.2, and 903.7 m/s, respectively. The inversion result is used to evaluate site classification, determine the maximum shear modulus of soil, provide basis for further seismic hazard analysis and site assessment or site zoning, etc. The result shows that the passive source surface-wave method is feasible in the site engineering seismic survey and can replace boreholes,shorten survey period, and reduce engineering cost to some extent.
Organic reefs, the targets of deep-water petroleum exploration, developed widely in Xisha area. However, there are concealed igneous rocks undersea, to which organic rocks have nearly equal wave impedance. So the igneous rocks have become interference for future exploration by having similar seismic reflection characteristics. Yet, the density and magnetism of organic reefs are very different from igneous rocks. It has obvious advantages to identify organic reefs and igneous rocks by gravity and magnetic data. At first, frequency decomposition was applied to the free-air gravity anomaly in Xisha area to obtain the 2D subdivision of the gravity anomaly and magnetic anomaly in the vertical direction. Thus, the distribution of igneous rocks in the horizontal direction can be acquired according to high-frequency field, low-frequency field, and its physical properties. Then, 3D forward modeling of gravitational field was carried out to establish the density model of this area by reference to physical properties of rocks based on former researches. Furthermore, 3D inversion of gravity anomaly by genetic algorithm method of the graphic processing unit(GPU) parallel processing in Xisha target area was applied, and 3D density structure of this area was obtained. By this way, we can confine the igneous rocks to the certain depth according to the density of the igneous rocks. The frequency decomposition and 3D inversion of gravity anomaly by genetic algorithm method of the GPU parallel processing proved to be a useful method for recognizing igneous rocks to its 3D geological position. So organic reefs and igneous rocks can be identified, which provide a prescient information for further exploration.
