A physical model of microstructure evolution including dislocation density rate and grain growth rate was established based on the deformation mechanism for the hot forming of a class of two-phase titanium alloys. Further,a set of mechanism-based constitu-tive equations were proposed,in which the microstructure variables such as grain size and dislocation density were taken as internal state variables for characterizing the current material state. In the set of constitutive equations,the contributions of different mecha-nisms and individual phase to the deformation behavior were analyzed. The present equations have been applied to describe a correla-tion of the flow stress with the microstructure evolution of the TC6 alloy in hot forming.
There exists an interaction between microstructural evolution and deformation behavior in high temperature deformation of titanium alloys. And the microstruc- ture of titanium alloys is very sensitive to the process parameters of plastic de- formation process. In this paper, on the basis of plastic deformation mechanism of metals and alloys, a microstructural model including dislocation density rate equa- tion and grain growth rate equation is established with the dislocation density rate being an internal state variable. Applying the model to the high temperature de- formation process of Ti60 titanium alloy, the average relative errors of grain sizes between the experiments and the predictions are 9.47% for sampled data, and 13.01% for non-sampled data.
The microstructure evolution in hot forming will affect the mechanical properties of the formed product. However, the microstructure is sensitive to the process variables in deformation process of metals and alloys. A microstructure evolution model of a titanium alloy in hot forming, which included dislocation density rate and primary α phase grain size, was presented according to the deformation mechanism and driving forces, in which the effect of the dislocation density rate on the grain growth was studied firstly. Applying the model to the high temperature deformation process of a TC6 alloy with deformation temperature of 11331223K, strain rate of 0.0150s^-1 and height reduction of 30%, 40% and 50%, the material constants in the present model were calculated by the genetic algorithm(GA) based objective optimization techniques. The calculated results of a TC6 alloy are in good agreement with the experimental ones.
