您的位置: 专家智库 > >

国家自然科学基金(10872189)

作品数:3 被引量:9H指数:2
相关作者:胡琦张青川曹鹏涛高云符师桦更多>>
相关机构:中国科学技术大学更多>>
发文基金:国家自然科学基金更多>>
相关领域:理学一般工业技术自动化与计算机技术金属学及工艺更多>>

文献类型

  • 3篇期刊文章
  • 2篇会议论文

领域

  • 4篇理学
  • 1篇金属学及工艺
  • 1篇自动化与计算...
  • 1篇一般工业技术

主题

  • 5篇合金
  • 3篇动态应变时效
  • 3篇应变时效
  • 3篇时效
  • 2篇屈服现象
  • 2篇AL-MG合...
  • 1篇电镜
  • 1篇动力系统
  • 1篇应变率
  • 1篇应变速率
  • 1篇溶质原子
  • 1篇射电
  • 1篇透射电镜
  • 1篇退火
  • 1篇退火温度
  • 1篇热分析
  • 1篇位错
  • 1篇温度
  • 1篇温度范围
  • 1篇析出相

机构

  • 4篇中国科学技术...

作者

  • 4篇曹鹏涛
  • 4篇张青川
  • 4篇胡琦
  • 3篇高云
  • 3篇符师桦
  • 1篇熊少敏
  • 1篇肖锐

传媒

  • 1篇物理学报
  • 1篇实验力学
  • 1篇Scienc...

年份

  • 1篇2011
  • 2篇2010
  • 2篇2009
3 条 记 录,以下是 1-5
排序方式:
Al-2.5wt%Mg合金中锯齿形屈服现象的TEM观察
<正>多种合金材料在一定的温度和应变率下拉伸时会出现一种特殊的塑性失稳现象,其表现为时域上的锯齿形应力流动和空域上的应变局域化,这种现象也被称为Portevin-Le Chatelier(PLC)效应。一般认为,锯齿形屈...
曹鹏涛张青川符师桦胡琦高云熊少敏肖锐
关键词:透射电镜位错析出相
文献传递
The influence of temperature on the PLC effect in Al-Mg alloy
2011年
An experimental investigation of the influence of temperature on the Portevin-Le Chatelier(PLC) effect in Al-Mg alloy is conducted.Under a certain strain rate,the PLC effect is present in the temperature range of 223-328 K.The serration amplitude increases monotonically with increasing temperature,whereas the behaviors of the serration period and the critical strain with temperature include a descending branch under corresponding low temperature range and an ascending branch under corresponding high temperature range.The analysis in relation with dynamic strain aging(DSA) indicates that the temperature plays an important role in the PLC effect by dictating the solubility and the diffusibility of solute atoms.Both the concentration and the diffusibility of solute atoms contribute to increasing the serration amplitude.Under the descending branch temperature range,the serration period mainly depends on the preparation phase and the dominant factor of critical strain is the velocity of dislocations.However,under the ascending branch temperature range,the serration period mainly depends on the pinning phase and the dominant factor of critical strain is the applied stress required for unpinning.
FU ShiHua ZHANG QingChuan HU Qi GONG Ming CAO PengTao LIU HaoWen
关键词:温度范围铝镁合金动态应变时效溶质原子应变速率
应变率和退火温度对Al-Mg合金LF5拉伸力学性能的影响
<正>在应变率为9.1×10~(-5)~1.8×10~(-2)的范围内,对经过不同退火温度热处理(473K~673K)的工业用AlMg合金LF5进行了系列拉伸试验,以探讨应变率和退火温度对其力学性能的影响。结果表明:材料...
曹鹏涛张青川符师桦胡琦
关键词:AL-MG合金退火应变率动态应变时效
文献传递
Al-Mg合金中锯齿形屈服现象的热分析被引量:7
2010年
研究了在室温、定加载应变率拉伸的情况下Al-Mg合金中的锯齿形屈服现象.伴随着锯齿形屈服现象的发生,试件表面温度场会发生变化.而红外相机能以较高的时间、空间分辨率记录下随时间变化的试件表面温度场图像.通过分析这些热图像,探讨了A,B两种类型带的传播规律,得到了局域变形带的带宽、倾角、传播速度等特征参数.在此基础上,引入热传导方程,求得了带内的应变率.实验和计算都发现B类型带产生时试件表面带外区域存在弹性收缩现象,由此提出以是否存在带外收缩变形作为划分A,B类型带的新标准.
曹鹏涛张青川符师桦胡琦高云
关键词:红外测温动态应变时效
Al-Cu合金Portevin-Le Chatelier效应的多重分形分析被引量:2
2010年
区别于传统的非线性动力学的吸引子结构分析,本文采用多重分形分析的研究方法讨论不同加载应变率条件下Al-Cu合金Portevin-Le Chatelier效应的多重分形特征,以揭示控制不同带型的内在动力机制。结果表明不管是哪种带型,都在一定尺度上存在着多重分形结构;同时发现B带的应力信号的均匀性高于A、C带,这反映了随着加载应变率的降低,动力系统由自组织临界性经拟周期状态过渡到混沌状态。
高云张青川胡琦曹鹏涛
关键词:动力系统
共1页<1>
聚类工具0