During the smelting process of the high Al steels,the reaction between SiO_2 in molten slag and dissolved aluminum in liquid steel always takes place.This aluminathermic reduction reaction will lead to the substitution of 1mol SiO_2 for 2/3mol Al_2O_3.Therefore,the investigations about the influence of the ratio of Al_2O_3 to SiO_2on viscosity and structure changes of mould flux during this process are very necessary.The viscosity variation of CaO-SiO_2-Al_2O_3-CaFv2 melts was studied by changing compositions considering the aluminathermic reduction reaction.It was found that viscosity increased monotonously with gradually increasing the substitution extent.According to the Raman analysis,the substitution of Al_2O_3 for SiO_2 leads to the decrease of non-bridging oxygen but the increase of bridging oxygen.Therefore,degree of polymerization and viscosity increase as the substitution extent increases.By comparing the measured viscosities with the model calculated values,it was found that both the recently developed Zhang′s model and Roboud model could describe the viscosity variation behavior of CaO-SiO_2-Al_2O_3-CaF_2 melts very well.
The carbon deposition behavior on nickel particles was observed within the temperature range from 400 to 800°C in a pure methane atmosphere.The topography,properties,and molecular structure of the deposited carbon were investigated using field-emission scanning electron microscopy(FESEM),temperature-programmed oxidation(TPO) technology,X-ray diffraction(XRD),and Raman spectroscopy.The deposited carbon is present in the form of a film at 400–450°C,as fibers at 500–600°C,and as particles at 650–800°C.In addition,the structure of the deposited carbon becomes more ordered at higher temperatures because both the TPO peak temperature of deposited carbon and the Raman shift of the G band increase with the increase in experimental temperature,whereas the intensity ratio between the D bands and the G band decreases.An interesting observation is that the carbon deposition rate is suppressed in the medium-temperature range(M-T range) and the corresponding kinetic mechanism changes.Correspondingly,the FWHM of the G and D1 bands in the Raman spectrum reaches a maximum and the intensities of the D2,D3,and D4 bands decrease to low limits in the M-T range.These results indicate that carbon structure parameters exhibit two different tendencies with respect to varying temperature.Both of the two group parameters change dramatically as a peak function with increasing reaction temperature within the M-T range.
Carbon deposition on nickel powders in methane involves three stages in different reaction temperature ranges. Temperature programing oxidation test and Raman spectrum results indicated the formation of complex and ordered carbon structures at high deposition temperatures. The values of I(D)/I(G) of the deposited carbon reached 1.86, 1.30, and 1.22 in the first, second, and third stages, respectively. The structure of carbon in the second stage was similar to that in the third stage. Carbon deposited in the first stage rarely contained homogeneous pyrolytic deposit layers. A kinetic model was developed to analyze the carbon deposition behavior in the first stage. The rate-determining step of the first stage is supposed to be interfacial reaction. Based on the investigation of carbon deposition kinetics on nickel powders from different resources, carbon deposition rate is suggested to have a linear relation with the square of specific surface area of nickel particles.
The kinetics of the leaching of carbothermic reduced titanium-bearing blast furnace slag in Panzhihua Iron and Steel Company with acid system under atmosphere pressure was studied. The results show that the temperature and concentration have significant influence on leaching of carbothermic reduced titanium-bearing blast furnace slag by acid. The experimental data of leaching indicate that the shrinking core model with chemical reaction controlled process is most applicable for the acid leaching. The apparent activation energy can be estimated to be from 23 to 32 k J/mol. Furthermore, the main products are TiC and SiO_2 after leaching.
